Click image to view full size image
This device is a high speed ethernet ADSL modemwhich provides one port switch. Support kinds of networkprotocols and runs steadily.
USB Bridge Broadband ADSL2 Modem
Detailed features: SOFTWARE
-ADSL Compliance
ANSI T1.413 Issue 2
ITU G.992.1 Annex A (G.dmt)
ITU G.992.1 Annex B (G.dmt) with UR2 compliant
ITU G.992.2 Annex A (G.lite)
ITU G.994.1 (G.hs)
Support dying gasp (optional)
Maximum Rate: 8 Mbps for downstream and 1 Mbps for upstream
-ADSL2 Compliance
ITU G.992.3 Annex A and Annex B (G.dmt.bis)
ITU G.992.4 Annex A and Annex B (G.lite.bis)
Support dying gasp (optional)
Maximum Rate: 12 Mbps for downstream and 1 Mbps for upstream
-ADSL2 Compliance
ITU G.992.5 Annex A and Annex B
Support dying gasp (optional)
Maximum Rate: 24 Mbps for downstream and 1 Mbps for upstream
-ATM Features
Compliant to ATM Forum UNI 3.1 / 4.0 Permanent Virtual Circuits (PVCs)
Support up to 8 PVCs for UBR, CBR, VBR-nrt, VBR-rt with traffic shaping
RFC2684 LLC Encapsulation and VC Multiplexing over AAL5
RFC2364 Point-to-Point Protocol (PPP) over ATM
RFC2225 Classical IP and ARP over ATM
RFC2516 PPP over Ethernet: support Relay (Transparent Forwarding) and Client functions
Support PPPoE, PPPoA, MER and Bridged mode
OAM F4/F5 End-to-End/Segment Loopback Cells
-Bridging Features
Supports self-learning bridge specified in IEEE 802.1d Transparent Bridging Supports up to 256 learning MAC addresses Transparent Bridging among 10/100 Mb Ethernet Supports IGMP Snooping Supports 802.1Q VLAN packet pass-through
-Security Features |
PAP (RFC1334), CHAP (RFC1994), and MS-CHAP/MS- |
CHAP2 for PPP session |
Firewall support IP packets filtering based on IP |
address/Port number/Protocol type |
Support DoS (Deny of Services) which detect & protect a |
number of attacks (such as SYN/FIN/RST Flood, Smurf, |
WinNuke, Echo Scan, Xmas Tree Scan, etc) |
-Configuration and Management |
User-friendly embedded web configuration interface with |
password protection in English or German |
Remote management access control |
Telnet session for local or remote management |
Firmware upgrades through HTTP, TFTP, or FTP |
Configuration file backup and restore |
HARDWARE |
-Interface |
One RJ-11 port for PSTN ISDN (C2-010-I) ADSL connection |
One RJ-45 ports for IEEE 802.3/802.3u 10/100 base-T |
auto-sensing and auto-crossover Ethernet connection |
-Regulatory Approvals and Compliance |
EMC: CE |
Safety: CB, LVD |
-Power Requirement and Operation Environ |
ment Requirement |
Power Adaptor: Input 230±5 VAC; Output 9VAC, 1A |
Power Consumption: max. 14.5 Watt |
Ambient Temperature: 0 to 40°C (32 to 96°F) |
Relative Humidity: 30% to 85% (non-condensing) |
-Physical |
Front Panel: 5 leds |
Dimensions |
Housing: 140 mm (L) x 115 mm (W) x 30 mm (H) |
Weight: 225 g |
USB Broadband Modem, ADSL2 Modem, Bridge Modem,Modem, USB Modem
USB Bridge Broadband ADSL2 Modem
